Leica Geosystems Leica 3D Disto - Manual - Manual (Page 160)

3D Disto, Software Applications 160
7.5.1 Workflow
Projector,
Start
3. The Viewfinder opens to measure the working area.
Measuring the
Working Area 1. Measure all important objects you want to consider (edges, corners, etc.)
2. If is enabled, press this key to close the outline. Then measure further points
of interest (slope mode only).
3. When all points are measured, press to continue.
1. Press Menu » Applications » Projector.
A pop-up offers three scan modes: horizontal,
slope and vertical.
2. Select your preference according to the
working area.

For horizontal mode only: the first measured point defines the level
that all following points refer to.