Leica Geosystems Leica 3D Disto - Manual User Manual
Page 164
Advertising
3D Disto, Software Applications
164
2. Each point and line can be selected by fingertip or stylus.
3. The grid can be moved up, down, left, and right on the screen in small steps using
/
/
/
. The perpendicular distance from a selected grid point to a
reference line is displayed. Tap on this distance to enter a value.
4. Press
for further grid alignment tools.
5. Press
to reset the grid position.
6. Press
to align grid parallel to a selected line.
7. Press
to turn the grid by 90°.
8. Press
to place the grid exactly on a reference point.
9. Press
to
proceed.
Lines between design points can be drawn on the screen if necessary
before use of the Parallel tool.
Use the
key at any time to go back to Point Design.
Advertising