Leica Geosystems Leica 3D Disto - Manual - Manual (Page 125)

125 3D Disto, Software Applications
Location Check
step-by-step If the 3D Disto was unintentionally moved, for example got bumped, the geometry
of the measured points will no longer fit with that of the previously measured points.
Start a Location Check to sustain the current accuracy/geometry.
1. To initiate a Location Check press Menu » Applications » Location » Location
Check.
2. If Secure Points are available, select Secure Point and press . The 3D Disto
will target the Secure Point automatically. Check laser point position with target
mark. Proceed that way for checking further points.
3. Press to close Secure Point gallery.

All Location applications can be cancelled by pressing .

If there are no Secure Points in the memory, no Location Check is
possible.

If laser point does not target the centre of the target mark, Relocation
is recommended.