KEYENCE BL-700 Series - Manual (Page 104)

Chapter 5 Serial Communication
90
5
● Online test ON
Command: #TEST1
Response: OK
● Online test OFF
Command: #QUIT
Response: OK
● Online test check
Command: #TEST
Response: #TESTn
n = 0: Online test OFF
1: Online test ON
Command: BCLR
Response: OK
Command: SSET
Response: OK
● Laser off
Command: LOCK
Response: OK
● Resetting Laser off
Command: UNLOCK
Response: OK
• When the Laser off command is executed, bar code read operation (laser
emission) is disabled until the Laser off command is reset by using UNLOCK
command.
• The Laser off command is retained even after the power is turned off.
Command: RESET
Response: OK
Online test mode
Sets to online test mode (
➮ see P. 60).
Clearing transmission buffer
Clears data stored in the transmission buffer.
Shift to setting mode
Enters the setting mode ( ➮ see P.4).
Laser off/Resetting Laser off
Turns off the laser emission when the laser beam may cause injury to an operator
(
➮ see P.2).
Reset
Resets the BL-700 software.