KEYENCE BL-700 Series - Manual (Page 90)

Chapter 4 Installing the Setup Software
76
4
4. If the settings of the BL-700 were successfully read, the following message
appears.
If the host computer failed to read the data, the following message appears.
If this message is displayed, check the following points:
• Check that [COM PORT] is set as shown in (1) when the 1st, 3rd and 5th
STABILITY LEDs from the top flash simultaneously (when in “setting data
send/receive waiting status”).
• Check that the power to the BL-700 is ON.
• Check that the RS-232C cable pin assignment of the BL-700 is the same as
that of the host computer.