KEYENCE BL-700 Series - Manual (Page 74)

Chapter 4 Installing the Setup Software
60
4
■ When using the PLC link
To enable the "Use PLC", set each item as follows:
• Set “Connected PLC”, “DM head address” and “Station No.”.
To set “DM head address”, enter a value (0000 to 9900) using the keyboard.
• To send a trigger signal to the BL series when the PLC link is enabled, set “PLC
trigger area”.
• To use “File Register”, set “File Register” to “Enable”. When “File Register” is
enabled, the following screen appears. The “File Register” can be used with the
Mitsubishi MELSEC-A series only.
Enter the block number (000 to 255) of the file register using the keyboard.
• PLC link
➮ P.106
• PLC trigger area
➮ P.113 to 115
• DM head address
➮ P.111
• File register
➮ P.107
The setting of the station
number is not displayed
when “KV Series” is selected.
The setting of the file register
is displayed only when
“MELSEC-A” is selected.
Tips