KEYENCE BL-700 Series - Manual (Page 88)

Chapter 4 Installing the Setup Software
74
4
3. Click on [Send settings (Save in BL EEP-ROM)]. The updated settings are then
sent to the BL-700.
4. If the settings were successfully sent to the BL-700, the following message
appears.
If the host computer failed to send the data to the BL-700, the following mes-
sage appears.
If this message is displayed, check the following points:
• Check that [COM PORT] is set as shown in (1) when the 1st, 3rd and 5th
STABILITY LEDs from the top flash simultaneously (when in “setting data
send/receive waiting status”).
• Check that the power to the BL-700 is ON.
• Check that the RS-232C cable pin assignment of the BL-700 is the same as
that of the host computer.