KEYENCE BL-700 Series - Manual (Page 91)

77
Chapter 4 Installing the Setup Software
4
4.5 Using Monitor
This setup software provides the “Monitor” program to check if the BL-700 can
send data properly. The “Monitor” program allows you to display the data read by
the BL series on the host computer’s monitor screen, and also to send a command
from the host computer to the BL-700 or BL series.
1. Click on [COM PORT] to set the communication parameters of the host com-
puter according to the current settings of the BL-700.
2. Click on [Monitor]. The MONITOR screen will appear.
3. When the BL series reads bar codes, the data read by the BL series is listed on
the screen (in the [Received Data] field). A record of up to 1000 lines of data
can be obtained. Using the scroll bar at the right of the [Received Data] field,
you can see the previous data.
Note: All commands should be entered in all uppercase characters. The BL cannot
accept lowercase characters.