KEYENCE BL-700 Series - Manual (Page 115)

101
Chapter 5 Serial Communication
5
■ Setting communication parameters 2 (only when PLC link is used)
PLC link model
Function Command Response Description
Change WP36n OK n = 0: PLC link disabled
n = 1: SYSNAC-C
n = 2: MELSEC-A
n = 3: KV
n = 4: MELSEC-A (File
register is used.)
Confirm 36n
Change OK n = 0: Disable
n = 1: Enable
Confirm RP37 37n
WP37n
Change WP45nn OK
Confirm RP45 45nn
RP36
nn = 00 to 99
(0000 to 9900)
Change WP47nn OK nn = 00 to 31
Confirm RP47 47nn
Change WP46nnn OK nnn = 000 to 255
Confirm RP46 46nnn
Error code
00, 02,
05, 07,
14
00, 02,
05, 09,
14
Trigger input
through PLC
link
DM head
address
PLC / station
number
File register
block number
Function Command Response Description
hh = Partition mark
(1 character)
* Specify the mark in
HEX (hexadecimal)
code.
Error code
00, 02,
05, 06,
10, 12,
14
■ Setting communication strings
Setting partition
mark when
additional
information is
used. Change WP50hh OK
Confirm RP50 50hh
hhh = Intermediate
delimiter (Up to 5
characters)
* Specify the mark in
HEX (hexadecimal)
code.
* To set no intermediate
delimiter, hhh = FF.
Setting interme-
diate delimiter
when multi label
reading mode 2
or 3 is used. Change WP54hhh... OK
RP54 54hhh... Confirm