KEYENCE BL-700 Series - Manual (Page 158)

Appendices
144
Appendices
Appendix M Default Setting List
■ Bar code setup
Parameter Code 1 Code 2 Code 3 Code 4
Code type CODE39 Coda bar UPC/EAN None
Maximum number of digits 32 32 –
Minimum number of digits 03 03 –
Send start/stop character Don’t send Send –
Start/stop character type Lowercase –
Test check digit Don’t test Don’t test –
Read JAN (More than All EAN 13-digit,
one can be selected.) EAN 8-digit
and UPC-E
are readable.
Number of output 13 digits
digits of UPC-A
Add “0” to UPC-E Don’t add
system code
Set specified-digit Don’t set Don’t set Don’t set –
output function
Set label reading in Don’t set Don’t set Don’t set –
the specified direction
■ Main setup
Read mode Single
Data send trigger After reading
Decode match count 2
Data addition function None
Reading error code ERROR
■ Trigger input setup
Selection method Level signal trigger
Input time 2 ms
Input polarity Normal Open
Start test mode at trigger input ON Don’t start
Start test mode at power ON Don’t start
Trigger ON command LON
Trigger OFF command LOFF