KEYENCE BL-700 Series - Manual (Page 39)

Chapter 2 Connection and Installation
2
25
2.4.2 Installing the BL-700 series
Installation method
Use the mounting holes on the side panel to install the unit.
■ Installation with no mounting bracket
• Select screws of the proper length by checking the thickness of the plate used
for mounting. (The screws provided are for use with the mounting bracket.)
• For the mounting hole diameter, see P.127.
■ Using the supplied mounting brackets
Vertical scanning
Horizontal scanning
• Use the set screw to secure the mounting bracket to the unit.
• For the mounting hole diameter, see P.127.
• When the insulating spacer is mounted, it can reduce the influence of noise
from the mounting bracket.
LASER ON
STB
OK/NG
TIMING
TEST
BL-700
M3 screws
M3 nuts
M3 screws
(accessory)
M4 screws
Washer (accessory)
Insulating spacer
(accessory)
M3 screws
(accessory)
LASER ON STB
OK/NG TIMING
TEST
BL-700
Insulating spacer
(accessory)
M4 screws
Washer (accessory)