YSI 6000UPG - Manual (Page 28)

2-18
To start, highlight Setup then press Enter. Check the default setup values.
Select this option to enter the number of the Comm port (1 or 2) to which the 6000 UPG is connected.
Be sure to press Enter to confirm a new entry. If the default setting is correct there is no need to
change it.
Select this option to check the baud rate. If the baud rate is not set to 9600, set it to 9600. To set
the baud rate, highlight it and press Enter. A list of possible baud rates will appear. Select 9600
from the list and press Enter. NOTE: The Model 6000
UPG default baud rate is 9600.
Select this option to specify the parallel port (LPT1, LPT2 or LPT3) to which your printer is
connected. If no printer is connected select LPT1. Press Enter after making your selection.
Select this option to select the type of printer connected to your computer system. From the list,
choose the selection that best describes your printer. If your printer is not on the list, refer to your
printer's instruction manual to determine what type of printer your printer emulates. Press Enter
after making your selection.
---DISPLAY -FORMATS---------COMPUTER-CONNECTIONS-------------
Date format:
MDY Comm port: 1
Date separator: / Baud rate 9600
Time separator: : Printer Port 1
Radix mark: . Printer type HP LaserJet laser
-------MORE-SETUP-------------COMPUTER-DISPLAY----------------------
Data capture setup...
Menu colors: User-defined menu colors
Advanced Setup... Plot colors: User-defined plot colors
Graphics mode: Automatic selection hi-res
Comm port:
Baud rate:
Printer port:
Printer type: