YSI 6000UPG User Manual
Page 31
2-21
You must now enable (or activate) the sensors which have been installed in your 6000
UPG
sonde.
Select 7. -Sensor setup
Enter the corresponding number to enable the sensor(s) that are installed on the sonde. The
activated selection is indicated by the asterisk.
You will see reference to TDG (total dissolved gas) in the Sensor setup menu. This is for
possible future upgrade and is not currently available for your 6000
UPG
.
NOTE
: The sensors that you have installed in your sonde may not include all that are shown
“enabled” in the above screen. The display is only an example.
After all installed sensors have been enabled, press 0 or Esc to return to the Main Menu.
Even if all of your installed sensors are enabled, the measurements for that sensor may not
appear on your display. In order for a specific parameter to be displayed:
1. The sensor must first be enabled (turned on).
========================================
Main
----------------------------------------
1. Run
5. System setup
2. Calibrate
6. Report setup
3. File
7. Sensor setup
4. Status
8. Diagnostics
Select option (0 for previous menu):
========================================
Sensor-setup
----------------------------------------
1-(*) Temp
7-( ) ISE2 ORP
2-(*) Cond
8-( ) ISE2 NH4+
3-(*) DO
9-( ) ISE2 NO3-
4-( ) Depth
A-(*) Batt
5-(*) ISE1 pH
B-( ) Turb
6-( ) ISE1 mV
C-( ) TDG
Select option (0 for previous menu):
========================================
Main
----------------------------------------
1. Run
5. System setup
2. Calibrate
6. Report setup
3. File
7. Sensor setup
4. Status
8. Diagnostics
Select option (0 for previous menu):