YSI 6000UPG - Manual (Page 51)

4-2
4.1.1. DISCRETE SAMPLE
Select 1. Discrete sample from the Run menu. The Run Discrete-sample menu will be displayed.
Select this option to start discrete sampling. After the initial sampling time interval has passed, data
will be displayed on the screen. The following prompt will appear just below the screen header:
*** 1-LOG last sample 2-LOG ON/OFF, 3-Clean optics ***
A single line of data can be logged to flash disk memory by pressing 1. A set of data can be logged
to flash disk by pressing 2. If you select 2 the following message will be displayed:
*** LOG is ON, hit 2 to turn it OFF, 3-Clean optics ***
If your unit has a turbidity probe installed, the optical surface will be cleaned by the wiper if you
select 3.
NOTE: The 3-Clean optics portion of the prompt will appear only if a turbidity probe is
installed in your unit and the sensor is enabled.
Select Esc or press 0 to exit discrete sampling.
========================================
Run
----------------------------------------
1. Discrete sample
2. Conditional Sample
3. Unattended sample
Select option (0 for previous menu):
========================================
Discrete-sample
----------------------------------------
1. Start sample
2. Site description
3. Sample interval
4. Close file
5. Set Auto-stop timer
Select option (0 for previous menu):
1. Start discrete sample