YSI 6000UPG - Manual (Page 70)

4-21
selection. To deactivate a parameter from screen display, simply press the number of the active
parameter, the asterisk will disappear, and the parameter will not appear on the screen during
operation.
NOTE: Choosing or not choosing parameters from this menu does not turn sensors on and off.
Regardless of how the report is set up, all active sensors will continue to collect data. See Section
4.7.
NOTE: You will see reference to TDG (total dissolved gas) in the Report setup menu. This is
for possible future upgrade and is not currently available for your 6000
UPG .
4.7 SENSOR SETUP
Select 7. Sensor setup to Enable or Disable (turn on or off) any sensor and to set up measurement
parameters for some sensors. This option also allows you to view or change information which is
specifically related to certain sensors.
From this menu, simply press the number of the sensor which you desire to enable or disable.
When a particular sensor is active, an asterisk will appear in the parentheses associated with the
selection. In the example, the temperature, conductivity, dissolved oxygen, pH, and battery sensors
are enabled. To disable a sensor, simply press the number of the active sensor, the asterisk will
disappear, and the sensor will no longer be active.
========================================
Main
----------------------------------------
1. Run
5. System setup
2. Calibrate 6. Report setup
3. File 7. Sensor setup
4. Status 8. Diagnostics
Select option (0 for previous menu):
========================================
Sensor-setup
----------------------------------------
1-(*) Temp
7-( ) ISE2 ORP
2-(*) Cond 8-( ) ISE2 NH4+
3-(*) DO 9-( ) ISE2 NO3-
4-( ) Depth A-(*) Batt
5-(*) ISE1 pH B-( ) Turb
6-( ) ISE1 mV C-( ) TDG
Select option (0 for previous menu):