Auto-Zone Control Systems ZoneView Plus Software Manual (Version 01C) - Manual (Page 19)

ZoneView Plus
Computer Front End 13
Print Unit Descriptions
Once all the units have been configured and a description has been entered, you can print
out a hard copy of all controllers installed on your jobsite. Select the Print Unit
Descriptions item located under the File menu. Only those loops that have controllers
installed or configured on them will generate a print out sheet. The print out shows what
the Jobsite / Phone List number is, the Loop Description you typed in and the Loop
Address.
The bottom half of the page contains the list of 60 possible controllers and any
descriptions you have typed in. If no unit exists or you haven't changed the default
description, you will see the message B01 - No Unit Exists for each controller and the
B01 will change to reflect the board address of the unit not there. For example, address
27 would show B27 - No Unit Exists.