Welltech SIPPBX 6200A - Manual (Page 11)

2.1.1 Network Configuration
To change your Network Setting, click Network, and then click the Network Setting
table. The screen appears as shown.
Figure Network: Network Setting
The following table describes the table in this screen
Table Network: Network Setting
- 11 -
Label Description
WAN
IP Support Select IP mode to provide IPv4 only, IPv6 only or dual
IPv4/IPv6.
Mode Select SIPPBX 6200A WAN port network mode to be Fixed IP,
DHCP or PPPoE.
IP Address Enter the IP Address. If user has set SIPPBX 6200A to be fixed
IP mode.
Subnet Mask Enter the Subnet Mask Address. If user has set SIPPBX 6200A
to be fixed IP mode.
Default Gateway Enter the Default Gateway Address. If user has set SIPPBX
6200A to be fixed IP mode.