Welltech SIPPBX 6200A - Manual (Page 61)

- 61 -
Features based on the other Outgoing Routing record.
Basic Setting
Primary/ Secondary/
Third/ Fourth/ Fifth/
Sixth/ Seventh/
Eighth User can set 8 priorities for each routing rule, if SIPPBX 6200A fails to
route to primary destination three times, it will try to route to secondary
or third destination and so on.
Destination Here you can find some destination (Trunk) for choosing. You
can define the destination for the prefix route.
Note:
z Before setting the Routing Table, you should set the Trunk
info in the Trunk page first. So that this field will contain the
Trunk ID for choosing.
z If the Trunk was setting to Dynamic in the Host field, but it
doesn’t register on SIPPBX 6200A, SIPPBX 6200A will skip
this “priority” and route call to next priority immediately
without trying. If the Trunk was setting to Address in the
Host field, but the Address is not reachable, SIPPBX 6200A
will try three times then route call to next priority.
Add To add assigned number. For example, you set 02 here and the
called number is 03123, the SIPPBX 6200A will add 02 then
send 0203123 as the called number.
Drop To drop specified length of number. For example, you set 2 here
and the called number is 03123, the SIPPBX 6200A will drop 03
then send 123 as outgoing number.
Note: If you set both of the Drop and Add, SIPPBX 6200A will
Drop first and then Add.
Route Password Set password here so the SIPPBX 6200A will request password
before sending the call to Trunk.
Routed Features
Guest Allow Enable Guest Allow will allow user who is not your subscriber
(Extension) to use such routing record. User can reach the Auto
attendant (The default Auto Attendant of SIPPBX 6200A is
**999) first then send call to Destination (Trunk), if you enable
Guest Allow. If you disable Guest Allow, only the Extension can
use this Routing record.
Fixed Outgoing Call
Rule SIPPBX 6200A will confirm the Fixed Trunk ID if you enable
Fixed Outgoing Call Rule. That means the SIPPBX 6200A will
route the call to a fixed Trunk if you enable this feature. For
example, you set Fixed Trunk ID for extension 101 to 888. And