Welltech SIPPBX 6200A - Manual (Page 16)

- 16 -
password for device to register on SIPPBX 6200A.
Subscriber MAC Select Autoconfig option to Subscriber Type. You must enter
the CPE Device MAC Address such as LP600N IP Phone MAC
address.
Call Group You can use the Call Group parameter to assign an Extension to
one or more groups.
Pickup Group You can use the Pickup Group option in conjunction with this
parameter to allow a ringing phone to be answered from
another extension.
Note:
The Pickup Group option is used to control which Call Groups a
channel may pick up—a channel is given authority to answer
another ringing channel if it is assigned to the same Pickup
Group as the ringing channel’s Call Group. By default, remote
ringing extensions can be answered with *8.
You can define multiple Call Groups and Pickup Groups for one
Extension by a “comma”. For example, you can input “1,3,5”
into Call Group or Pickup Group.
Dial Plan Define the dialing plan for Extension. It specifies the location of
the instruction used to control what extension is allowed to do,
and what to do with incoming calls for this extension. In this
field, you can Choose 5 dial levels for Extension, including
[ext-only], [ext+R1], [ext+R12], [ext+R123], [ext+allroutes].
You can define an “Outgoing call” record, to a certain Route
Level, as R1, R2…, etc. [ext-only] means this subscriber can
only call to Extension. [ext+R1] means the subscriber with
such Dial Plan can call to Extension and Route Level with R1.
[ext+R12] means the subscriber with such Dial Plan can call to
Extension and Route Level with R1 and R2. [ext+R123] means
the subscriber with such DialPlan can call to Extension and
Route Level with R1, R2 and R3. [ext+allroutes] means the
subscriber with such Dial Plan can call to Extension and Route
Level with R1, R2, R3 and R4(allroutes).
Note:
For more information about Route Level, please refer to the
user manual: CH3.1.8 Outgoing Routing.
Keypad User can select Keypad type to be RFC2833, In-band, SIP-Info
and Auto. You can choose Auto to auto select the Keypad type.
Choose RFC2833, Inband or SIP-Info here will force the
Extension use RFC2833, Inband or SIP-Info accordingly and