Yaskawa SmartTrac AC1 - Manual (Page 35)

SMART TRAC AC1
Technical Manual TM 3554-000 Smart Trac AC1 Installation
••
4-15
IP Address
Subnet Mask
Gateway Address
DNS Server Addr
TCP/IP Config
Inverter Type
Serial Download?
Firmware Version
Start System?
ENTER
COM1 Config
ENTER
ENTER
ENTER
ENTER Starting OS
Load from COM1..
Erase FLASH...
Program FLASH...
MagneTek
Smart Trac
MENU
Starting OS
Baud Rate
If 2 sec
timeout
occurs
Operating System
Monitor
Boot Code
Flash Access ENTER
Erase this?
User Program
2ms Torq Update
5ms Torq Update
ENTER
Figure 5. The Smart Trac AC1 Boot Process.
Refer to "Addresses and subnet mask" for information on setting the TCP/IP
address through the Boot Menu.
This function changes the Torque Update parameter from 2 milliseconds to 5
milliseconds. Do not change this function without the approval of an application
engineer.
Using this function enables you to change the baud rate of the RS-232
communications port located on display panel. Normally, this port is only used
to download operating system, monitor and boot programs. It should not
normally be changed.
TCP/IP Address
Inverter Type
COM1 Config