Avago Technologies LSI53C1000R User Manual

Page 153

Advertising
background image

SCSI Registers

4-41

Version 2.2

Copyright © 2000–2003 by LSI Logic Corporation. All rights reserved.

•

During a Transfer Control instruction, the
Compare Data (bit 18) and Compare Phase (bit 17)
bits are set in the

DMA Byte Counter (DBC)

register

while the LSI53C1000R is in target mode.

•

During a Transfer Control instruction, the Carry Test
bit (bit 21) is set and either the Compare Data (bit 18)
or Compare Phase (bit 17) bit is set.

•

A Transfer Control instruction is executed with the
Wait for Valid phase bit (bit 16) set while the chip is in
the target mode.

•

A Load and Store instruction is issued with the
memory address mapped to the operating registers of
the chip, not including ROM or RAM.

•

A Load and Store instruction is issued when the register
address is not aligned with the memory address.

•

A Load and Store instruction is issued with bit 5 in the

DMA Command (DCMD)

register cleared or bits 3 or

2 set.

•

A Load and Store instruction is issued when the count
value in the

DMA Byte Counter (DBC)

register is not

set at 1, 2, 3, or 4.

•

A Load and Store instruction attempts to cross a
Dword boundary.

•

A Memory Move instruction is executed with one of
the reserved bits in the

DMA Command (DCMD)

register set.

•

A Memory Move instruction is executed with the
source and destination addresses not aligned.

•

A 64-bit Table Indirect Block Move instruction is
executed with a selector index value greater than 0x16.

•

If the Select with ATN/ bit, bit 24, is set for any I/O
instruction other than a Select instruction.

Advertising
This manual is related to the following products: