Symmetricom EDGE CLOCK 1000 - Manual (Page 204)

Appendix A Factory Default Values
Default Command Access Levels
204 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008
Default Command Access Levels
This section describes the default access level for the TL1 commands described in
this guide.
Table A-1 also describes whether you can edit the default command
access level using the ED-CMD-SECU command (see the TimeProvider TL1
Reference Guide for details on this command). For a complete list of commands
and their access levels, see the TimeProvider TL1 Reference Guide.
Table A-1. Default Access Levels for TL1 Commands
Command Default Access Level Editable?
RTRV-USER-SECU Security Yes
ENT-USR-SECU Security No
ED-USER-SECU Security No
ED-PID Security Yes
ENT-PID User Yes
DLT-SECU Security Yes
DLT-USR-SECU Security Yes
RTRV-CMD-SECU Admin Yes
ED-CMD-SECU Admin No
CPY-MEM Admin Yes
RTRV-DAT User Yes
ED-DAT Admin Yes
RTRV-EQPT User Yes
ED-EQPT Admin Yes
RTRV-SYNC User Yes
ED-SYNC Admin Yes
RTRV-ATTR User Yes
SET-ATTR Admin Yes
RTRV-LOG User Yes
INIT-LOG Admin Yes
INIT-SYS Admin Yes
RTRV-SYS-MODE User Yes
SET-SYS-MODE Admin Yes
OPR-ACO-ALL User Yes