Lucent Technologies 6000 - Manual (Page 112)

3-68 MAX 6000/3000 Network Configuration Guide
Configuring WAN Access
Configuring inbound calls
Does called number with
subaddress match Ans N# in
the Ethernet (Mod Config)
profile?
From preceding page: “B” From preceding page “A”
Is bridge/router module
available? No
Route call to it.
Yes
Does called number with
subaddress match Ans N# in
a LAN Modem profile?
Is a digital modem
available?
No
Route call to it.
Yes
Does called number with
subaddress match Ans N# in
a V.110 profile?
Is a V.110 module
available?
No
Route call to it.
Yes
Perform the
following Ans N#
steps without
including the
subaddress in the
Is the serial-host port
available? No
Route call to it.
Yes
Does called number with
subaddress match Ans N# in a
Port Config (invs-mux) profile?
Have the above four Ans N#
steps been performed without
including the subaddress in
the match?
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Is call answered on a channel whose slot and port
parameters (Ch N Slot, B1 Slot, B2 Slot) (Ch
N Prt/Grp, B1 Prt/Grp, B2 Prt/Grp) point to a
serial-host port (invs-mux) module, and is the port
Route call to port.
Yes
Is call answered on a channel whose slot parameter
(Ch N Slot, B1 Slot, B2 Slot) points to
bridge/router module, and is the bridge/router Yes
Route call to unit’s bridge/
No
Is call answered on a channel whose slot parameter
(Ch N Slot, B1 Slot, B2 Slot) points to a
digital modem module, and is a modem in any slot
available? Yes
Route call to any available
digital modem.
No
No
Is call answered on a channel whose slot
parameter (Ch N Slot, B1 Slot, B2 Slot) points to
a V.110 module, and is a V.110 module available?
Yes
Route call to any available
V.110 module.
Continue next page
No
router.