Lucent Technologies 6000 - Manual (Page 314)

6-28 MAX 6000/3000 Network Configuration Guide
Configuring X.25
Configuring X.32 profiles for incoming switched X.25 connections
Net2Net circuit mode
With traditional X.25 connections, you configure one X.25 switched connection per client, as
in Figure 6-3.
Figure 6-3. Traditional X.25 connection
But a MAX 6000 unit can enable several X.25 clients to share a single connection to an X.25
network. In Figure 6-4, the X.25 switch connects to the MAX 6000. The X.25 switch sees the
MAX 6000 as a terminating device—Data Terminal Equipment (DTE). The clients see the
MAX 6000 as an X.25 switch—Data Communications Equipment (DCE).
Figure 6-4. Net2Net circuit mode
To configure Net2Net circuit mode, proceed as follows for each client:
1 Open the Ethernet > Connections > client’s profile > X.32 profile.
2 Set Encaps to X.32.
3 Set Calling # to the client’s number.
4 Set Called # to the number of the MAX ISDN line.
5 Set the Encaps Options > X.25 Prof parameter to the name of a profile in the Ethernet >
X.25 menu, that is, to the name of the X.25 profile to be used for this client.
6 Set the Appl Mode parameter to Net2Net.
7 Exit the profile and, at the exit prompt, select the exit and accept option .
8 Open the Ethernet > X.25 profile to be used for this client.
9 Set Active to Yes.
10 Set Call Type to Switched.
DCE
sX.25
Client
DTE
DCE sX.25
Client
DTE
DCE
sX.25
Client
DTE
X.25 switch
Client
Client
sX.25
MAX 6000
Nailed X.25
X.25 switch
DCE
DTE DCE
DTE
DTE