Lucent Technologies 6000 - Manual (Page 409)

Configuring IP Routing
Configuring WAN interfaces
MAX 6000/3000 Network Configuration Guide 9-45
Figure 9-14. Example of a numbered interface
The numbered interface addresses are:
• IF Adrs=10.5.6.7/24
• WAN Alias=10.5.6.8/24
Figure 9-14 also shows an unnumbered interface. The 10.1.2.3/32 connection uses a
single system-based address for both the MAX itself and the dial-in user. To configure the
unnumbered and numbered interfaces:
1 Open Ethernet > Mod Config > Ether Options and verify that the IP Adrs parameter is set
to the IP address of the Ethernet interface of the MAX unit:
Ethernet
Mod Config
Ether options...
IP Adrs=10.2.3.4/24
2 Exit the profile and, at the exit prompt, select the exit and accept option.
3 Open the Connection profile and configure the required parameters, then open the IP
Options subprofile.
4 Set the LAN Adrs parameter to specify the IP address of the Ethernet interface of the
remote device:
Ethernet
Connections
numbered
IP options...
LAN Adrs=10.7.8.9/24
5 Set the WAN Alias parameter to specify the numbered interface address for the remote
device:
IP options...
WAN Alias=10.5.6.8/24
6 Exit the profile and, at the exit prompt, select the exit and accept option.
Following is a comparable RADIUS profile:
numbered Password = "localpw"
Service-Type = Framed-User,
Framed-Protocol = PPP,
Ascend-Route-IP = Route-IP-Yes,
Framed-IP-Address = 10.5.6.8,
Framed-IP-Netmask = 255.255.255.0,
MAX
WAN
10.2.3.4/24
10.5.6.7/24
10.5.6.8/24
10.7.8.9/24
10.1.2.3/32