Lucent Technologies 6000 - Manual (Page 130)

3-86 MAX 6000/3000 Network Configuration Guide
Configuring WAN Access
Configuring MAXDAX
Users specify which Dial Plan profile MAX 2 uses for their calls. In this example, the system
administrator configures two Dial Plan profiles, 31 and 32, and tells the users which profile to
use for specific destinations. Dial Plan profile 31 has the following configuration:
System
Dial Plan
PRI plan
Name=PRI plan
Call-by-Call=6
Data Svc=64K
PRI # Type=National
NumPlanID=ISDN
Transit #=
Bill #=
Dest #=14155551212
PrependDigits=
Because the system administrator specifies a Dest # value of 14155551212, the MAX 2 dials
that number to make the outbound call.
Example of MAXDAX configuration (E1)
This section describes one MAXDAX environment, including specific parameter settings.
Routing calls on the basis of the channel on which MAX 2 receives the call
This example illustrates a call-routing process for the MAX unit labeled MAX 2 in Figure 3-6.
The physical environment for this example is the same as displayed in Figure 3-5, but MAX 2
routes calls on the basis of the channel on which it receives the call from MAX 1.
Figure 3-6 shows an example of a MAXDAX installation.
Figure 3-6. Sample MAXDAX (E1) installation
PRI
PSTN
Pipeline 75
Video System A
E1
PRI
Video System C
Serial line
MAX 1 MAX 2
Video System B
Serial line