Lucent Technologies 6000 - Manual (Page 440)

11-6 MAX 6000/3000 Network Configuration Guide
Setting Up Virtual Private Networks
Configuring ATMP tunnels
Station=name-of-home-agent
Active=Yes
Dial #=555-1212
Route IP=Yes
IP options...
LAN Adrs=10.1.2.3/24
Following are the parameters (shown with sample settings) for using RADIUS authentication:
Ethernet
Mod Config
Auth...
Auth=RADIUS
Auth Host #1=10.23.45.11/24
Auth Host #2=0.0.0.0/0
Auth Host #3=0.0.0.0/0
Auth Port=1645
Auth Timeout=1
Auth Key-=[]
Auth Pool=No
Auth Req=Yes
Password Server=No
Password Port=N/A
Local Profile First=No
Sess Timer=0
Auth Src Port=0
Auth Send Attr 6,7=Yes
Following are the parameters (shown with sample settings) for creating RADIUS user profiles
for mobile clients running TCP/IP:
node1 Password="top-secret"
Ascend-Metric=2,
Framed-Protocol=PPP,
Service-Type= * check these in this section
Ascend-IP-Route=Route-IP-Yes,
Framed-IP-Address=200.1.1.2,
Framed-IP-Netmask=255.255.255.0,
Ascend-Primary-Home-Agent=10.1.2.3,
Ascend-Home-Agent-Password="private"
Ascend-Home-Agent-UDP-Port=5150
Tunnel-Type=ATMP,
Tunnel-Server-Endpoint="atmp-ha1.example.com",
Tunnel-Password="tunnel-password"
Following are the parameters (shown with sample settings) for creating RADIUS user profiles
for mobile clients running NetWare:
node2 Password="ipx-unit"
User-Service=Framed-User,
Ascend-Route-IPX=Route-IPX-Yes,
Framed-Protocol=PPP,
Ascend-IPX-Peer-Mode=IPX-Peer-Dialin,
Framed-IPX-Network=40000000,
Ascend-IPX-Node-Addr=123456789012,