Lucent Technologies 6000 - Manual (Page 59)

Configuring WAN Access
Configuring T1 lines
MAX 6000/3000 Network Configuration Guide 3-15
Ethernet
Mod Config
Auth
Timeout Busy=No
Configuring robbed-bit signaling
For robbed-bit signaling, set the line you are configuring to Trunk service, and set the signaling
mode and the robbed-bit control mechanism. To configure a T1 line for robbed-bit signaling,
proceed as follows:
1 Open a Net/T1 > Line Config > Line Config profile and, depending on which line you are
configuring, set the 1st Line or 2nd Line parameter to Trunk.
2 Open the subprofile for the line you have set to Trunk, and set Sig Mode to Inband.
3 In the same profile, specify the Rob Ctl parameter to specify the robbed-bit call-control
mechanism required by your carrier.
4 Set the Framing Mode parameter to specify the physical-layer frame format of the T1 line.
5 Set the Encoding parameter to specify the type of encoding that the line uses at the
physical-link layer.
6 Set the Send Disc parameter to specify the number of seconds the MAX unit waits, from
the time the call is presented, before clearing the call.
7 Set the Overlap Receiving parameter to enable the unit to gather the complete called
number from the network switch.
8 Exit the profile and, at the exit prompt, select the exit and accept option.
If the profile you have configured is not the active profile, activate it as described in
“Activating a profile” on page 2-7.
Example of robbed-bit configuration
Following is an example of T1-line configuration using all switched channels and the default
inband (robbed-bit) signaling mode. (Only relevant parameters are shown.)
NET/T1
Line Config
Swtchinbnd
Name=Swtchinbnd
1st Line=Trunk
2nd Line=Disabled
Line 1...
Sig Mode=Inband
Rob Ctl=Wink-Start
Framing Mode=D4
Encoding=AMI
Send Disc=0
Overlap Receiving=Yes
Using NFAS signaling
When you configure two T1 lines for NFAS signaling, they share a D channel. Configure one
line with a primary D channel and the other with a secondary D channel. The secondary D