Lucent Technologies 6000 User Manual

Page 406

Advertising
background image

9-42

MAX 6000/3000 Network Configuration Guide

Configuring IP Routing
Configuring WAN interfaces

To configure the Site B Pipeline:

1

Open the Connection profile for the Site A MAX.

2

Set the Station parameter to specify the Site A MAX unit’s name, set the Active profile to
activate the profile, and specify the desired encapsulation options. For example:

Ethernet

Connections

Connection profile 1

Station=MAXA

Active=Yes

Encaps=MPP

Encaps options...

Send Auth=CHAP

Recv PW=localpw

Send PW=remotepw

3

Set the Route IP parameter to enable IP routing and set the LAN Adrs parameter to specify
the IP address of the MAX at Site A.

Route IP=Yes

IP options…

LAN Adrs=10.2.3.1/22

4

Exit the profile and, at the exit prompt, select the

exit and accept

option.

Following are comparable RADIUS profiles:

pipeline1 Password = "localpw"

Service-Type = Framed-User,

Framed-Protocol = PPP,

Framed-IP-Address = 10.9.8.10/22,

Framed-IP-Netmask = 255.255.252.0

route-max-1 Password = "ascend", Service-Type = Outbound-User

Framed-Route = "10.9.8.10/22 10.9.8.10 1 n pipeline1-out"

pipeline1-out Password = "localpw", Service-Type = Outbound-User

User-Name = "pipeline1",

Ascend-Dial-Number = "9-1-333-555-1212",

Framed-Protocol = PPP,

Framed-IP-Address = 10.9.8.10,

Framed-IP-Netmask = 255.255.252.0,

Ascend-Send-Auth = Send-Auth-PAP,

Ascend-Send-Password = "remotepw"

Configuring a router-to-router connection on a subnet

In the sample network illustrated in Figure 9-13, the MAX unit connects telecommuters with
their own Ethernet networks to the corporate backbone. The unit is on a subnet, and assigns
subnet addresses to the telecommuters’ networks.

Advertising
This manual is related to the following products: