Lucent Technologies 6000 - Manual (Page 159)

Configuring Individual WAN Connections
The Connection profile
MAX 6000/3000 Network Configuration Guide 4-27
X.25 Prof
The X.25 Prof parameter specifies the name of an X.25 profile to use for this connection. To
guard against misconfiguration, the MAX unit does not allow you to save an active Connection
profile specifying X.25 encapsulation unless the named X.25 profile is defined and active.
Recv PW
The Recv PW parameter specifies the password that the unit expects to receive from the far
end while the connection is being authenticated. If this password is not sent by the far-end
device, authentication fails. For X.25/PAD, the password can contain 48 characters.
Encaps=X25/IP
When Connections > Connection profile > Encaps=X25/IP, the following parameters appear in
the interface for Ethernet > Connections > Connection profile > Encaps Options:
Ethernet
Connections
Connection profile
X.25 Prof
LCN
Encaps Type
Reverse Charge
RPOA
CUG Index
NUI
Max Unsucc. calls
Inactivity Timer
MRU
Call Mode
Answer X.121 Addr
Remote X.121 Addr
LCN
The LCN parameter specifies the Logical Channel Number (LCN) to use for a Permanent
Virtual Connection (PVC) using X.25. On an X.25 connection, an LCN is a unique number
assigned to each Virtual Circuit (VC). On a X.25 network, a VC is a bidirectional data path
between two endpoints.
Encaps Type
The Encaps Type parameter specifies which encapsulation to use when calling the remote IP
network across X.25.
Max Unsucc. Calls
The Max Unsucc. Calls parameter specifies the maximum number of unsuccessful X.25 calls
the unit tries to place before dropping the modem connection.