Lucent Technologies 6000 - Manual (Page 469)

Setting Up Virtual Private Networks
Configuring L2TP tunnels for dial-in clients
MAX 6000/3000 Network Configuration Guide 11-35
Figure 11-9. L2TP tunnel setup using tunnel assignment IDs
Following are the RADIUS profiles that support the configuration described in Figure 11-9:
modemuser Password = "test"
User-Service = Framed-User,
Framed-Protocol = PPP,
Test-Idle-Limit = 0,
Tunnel-Type = L2TP :1,
Tunnel-Server-Endpoint = 1.1.1.1 :1,
Tunnel-Client-Auth-ID = taos-unit: 1,
Tunnel-Password = shared,
Tunnel-Assignment-ID = modem-taid:1
isdnuser Password = "test"
User-Service = Framed-User,
Framed-Protocol = PPP,
Test-Idle-Limit = 0,
Tunnel-Type = L2TP :1,
Tunnel-Server-Endpoint = 1.1.1.1 :1,
Tunnel-Client-Auth-ID = taos-unit: 1,
Tunnel-Password = shared,
Tunnel-Assignment-ID = isdn-taid:1
RADIUS accounting support
RADIUS accounting Stop records display the value for the Tunnel-Assignment-ID attribute
used for the user-session. For example:
Tue May 2 15:58:08 2000
User-Name = "modemuser"
NAS-Identifier = 2.2.2.2
NAS-Port = 11313
NAS-Port-Type = Async
Acct-Status-Type = Stop
Acct-Delay-Time = 0
Acct-Session-Id = "317658341"
Acct-Authentic = Local
Acct-Session-Time = 112
Acct-Input-Octets = 2155
Acct-Output-Octets = 513
Acct-Input-Packets = 23
Acct-Output-Packets = 14
WAN
IP
2.2.2.2
1.1.1.1
2.2.2.3
10.1.1.1/24 (modem user)
20.1.1.1/24 (ISDN user)
1.1.1.2
LAC
LNS
tunnel named
modem-taid
tunnel named
isdn-taid