Example of a ppp connection, Example of a ppp connection -45, Figure 4-1 a ppp connection -45 – Lucent Technologies 6000 User Manual

Page 177

Advertising
background image

Configuring Individual WAN Connections

Configuring PPP connections

MAX 6000/3000 Network Configuration Guide

4-45

Example of a PPP connection

Figure 4-1 shows the MAX unit with a PPP connection to a remote user who is running
Windows 95 with a TCP/IP stack and PPP dialup software. The dial-in user has a modem, so
the call is asynchronous and uses only one channel.

Figure 4-1. A PPP connection

To configure this PPP connection:

1

Make sure the Answer profile enables PPP encapsulation and has the appropriate routing,
bridging, and authentication settings. For example:

Ethernet

Answer

Encaps

PPP=Yes

PPP Options

Route IP=Yes

Route IPX=Yes

Bridge=Yes

Recv Auth=Either

2

Exit the profile and, at the exit prompt, select the exit and accept option.

3

Open an Ethernet > Connections > Connection profile.

4

Specify the name of the remote device and activate the profile. For example:

Ethernet

Connections

tommy

Station=tommy

Active=Yes

Note:

Make sure that you specify the Station name exactly, including case.

5

Select PPP encapsulation and set the appropriate PPP Options. For example:

Encaps=PPP

Encaps Options

Send Auth=CHAP

Send PW=remotepw/A

Recv PW=localpw

The Send Auth parameter should be set to CHAP or PAP. Both sides of the connection
must support the selected authentication protocol and the selected compression methods.

6

Exit the profile and, at the exit prompt, select the exit and accept option.

Following is a comparable RADIUS profile:

tommy Password = "localpw"

Service-Type = Framed-User,

MAX

WAN

Modem

Windows95
with TCP/IP
and PPP

Advertising
This manual is related to the following products: