Lucent Technologies 6000 - Manual (Page 301)

Configuring X.25
Setting up X.25 PAD sessions
MAX 6000/3000 Network Configuration Guide 6-15
3 Data forwarding
characters 0—None (full packet)
1—Alphanumeric
2—Carriage return (the default)
4—ESC, BEL, ENQ, ACK
8—DEL, CAN, DC2
16—ETX, EOT
32—HT, LT, VT, FF
64—All other characters in columns 0 and 1
of International Alphabet #5
4 Idle timer delay 0—No timer
1–255—Delay value in twentieths of a second
5 Ancillary device
control 0—Not operational
1—Use X-ON (DC1 of International Alphabet
#5) and X-OFF (DC3 of International
Alphabet #5)
6 PAD service and
command signals 0—Do not transmit service signals
1—Transmit service signals
7 PAD operation on
receipt of break
signal from the
start-stop mode
DTE 0—No action
1—Transmit Interrupt packet
2—Reset
4—Indication of break (PAD message)
8—Escape from data transfer
16—Discard output to DTE-C
21—Combine actions 1, 4, and 16
8 Discard output 0—Normal data delivery (the default)
1—Discard output to DTE-C
9 Padding after
carriage return 0—No padding
1–7—Number of padding characters inserted
after the carriage return
10 Line folding 0—No line folding (the default)
1–255—Number of characters per line
11 Terminal-server
access speed 10—50 bps
5—75 bps
9—100 bps
0—110 bps
1—134.5 bps
6—150 bps
8—200 bps
2—300 bps
...
Table 6-2. X.3 parameters (continued)
Parameter Description Possible values