Lucent Technologies 6000 - Manual (Page 146)

4-14 MAX 6000/3000 Network Configuration Guide
Configuring Individual WAN Connections
The Answer profile
Filter-related parameters
The Answer > Session Options subprofile contains the following filter-related parameters:
Timing parameters
The Answer > Session Options timing parameters define how long a session can remain
inactive before a call is cleared, whether the MAX unit uses the terminal-server idle timer, and
how long a terminal server can remain idle before the session disconnects. Following are the
parameters:
Miscellaneous Session Options parameters
The following Answer > Session Options parameters further define the session for an
incoming call:
Parameter Specifies
Data Filter Number of a filter used to determine if packets should be forwarded or
dropped. If both a call filter and data filter are applied to a connection,
the MAX unit applies a call filter after applying a data filter. (Only
those packets that the data filter forwards can reach the call filter.)
Call Filter Number of a filter used to determine if a packet should cause the idle
timer to be reset or a call to be placed. If both a call filter and data filter
are applied to a connection, the unit applies a call filter after applying a
data filter. (Only those packets that the data filter forwards can reach
the call filter.)
Filter Persistence Whether or not the filter or firewall assigned to an Answer profile
should persist after the call has been disconnected.
Parameter Specifies
Idle Number of seconds the MAX unit waits before clearing a call when a
session is inactive.
TS Idle Mode Whether or not the unit uses the terminal-server idle timer and, if so,
whether both the user and host must be idle before the unit disconnects
the session.
TS Idle Number of seconds that a terminal-server connection must be idle
before the unit disconnects the session.
Parameter Specifies
Max Call Duration Maximum duration in minutes of an established session for an
incoming call. The connection is checked once per minute, so the
actual time of the call is slightly longer (usually less than a minute
longer) than the actual time you set.
Preempt Number of idle seconds the MAX unit waits before using one of the
channels of an idle link for a new call.