Lucent Technologies 6000 - Manual (Page 131)

Configuring WAN Access
Configuring MAXDAX
MAX 6000/3000 Network Configuration Guide 3-87
Note: Because MAX 2 considers Answer Plan profiles after determining whether it should
route on the basis of specific channels, the system administrator could leave the configuration
from the preceding example as it is.
The system administrator configures MAX 1 to deliver calls to MAX 2 on specific channels.
MAX 1 sends calls with calling number 1234 to channel 1 or 2 of the leased T1 line on
MAX 2. The system administrator configures the Net/T1 > Line Config > Line Config profile
> Line 1 > Net2Net Incoming Calls profile as follows:
Net/T1
Line Config
Line Config profile
Line 1...
Net2Net Incoming Calls
Ch 1=Switched
Ch 1 Dest ChanGroup=1
Ch 1 Dial Plan #=0
Ch 1 #DialPlanSelDigits=2
Ch 2=Switched
Ch 2 Dest ChanGroup=1
Ch 2 Dial Plan #=0
Ch 2 #DialPlanSelDigits=2
Ch 3=Switched
Ch 3 Dest ChanGroup=0
Ch 3 Dial Plan #=0
Ch 3 #DialPlanSelDigits=0
MAX 2 routes any call it receives on channel 1 or 2 to the first available channel assigned to
channel group 1. MAX 2 identifies the Dial Plan profile number by examining the leading two
digits of the called number.
Because the system administrator sets Dest ChanGroup to 1 in the Net2Net Incoming Call
profile, at least one channel of the PRI line must belong to channel group 1. The system
administrator configures the outgoing-calls profile as follows:
Net/T1
Line Config
Line Config profile
Line 1...
Net2Net ChanGroup ID
Ch 1=Switched
Ch 1 ChanGroup=1
Ch 2=Switched
Ch 2 ChanGroup=1
The system administrator can assign more channels to channel group 1 if users connected to
the PBX require outbound dialing on the PRI line.
Users specify which Dial Plan profile MAX 2 uses for their calls. In this example, the system
administrator configures two Dial Plan profiles, 31 and 32, and tells the users which profile to
use for specific destinations. Dial Plan profile 31 has the following configuration:
System
Dial Plan
PRI plan