Lucent Technologies 6000 - Manual (Page 116)

3-72 MAX 6000/3000 Network Configuration Guide
Configuring WAN Access
Configuring outbound calls
Ethernet
Connections
Connection profile
Dial #=5-555-1212
Host/AIM6 (or Host/Dual)
PortN Menu
Directory
call profile
Dial #=4-555-1217
Host/BRI
Line Config
Line Config profile
Line N...
Dial Plan=Trunk Grp
If Dial Plan=Trunk Grp in the Mod Config > WAN Options profile, and Dial # has a
single-digit dialing prefix from 4 to 9 in a Connection or call profile, the unit places the call
through channels in that trunk group.
Dialing through the extended dial plan
When the extended dial plan is specified for a particular port, the trunk-group number is the
first digit in a three-digit dialing prefix in which the next two digits are interpreted as the
number of a Dial Plan profile.
The extended dial plan relates only to PRI lines. It uses a specified trunk group, but accesses a
Dial Plan profile to obtain PRI parameters for the outbound call. The extended dial plan is
typically used to route calls from a terminating device on a Host/BRI line out to the WAN over
PRI channels. However, it can also be used to set up the PRI parameters for other outbound
calls. Following are the related parameters (shown with sample settings):
System
Dial Plan
host1
Name=host1
Call-by-Call=8
Data Svc=56KR
PRI # Type=National
Transit #=222
Bill #=
Host/BRI
Line Config
Line Config profile
Line N...
Dial Plan=Extended
The following example shows how to specify the extended dial plan from an AIM port or the
Ethernet network:
Host/AIM6 (or Host/Dual)
PortN Menu
Port Config