Lucent Technologies 6000 - Manual (Page 169)

Configuring Individual WAN Connections
The Connection profile
MAX 6000/3000 Network Configuration Guide 4-37
OSPF Options
The Ethernet > Connections > Connection profile > OSPF Options subprofile includes the
following parameters that define the OSPF area and type on the interface, timing issues for
OSPF packets, priority of the OSPF router, and authentication for validating OSPF packets:
Authentication parameters
The Ethernet > Connections > Connection profile > OSPF Options subprofile includes the
following parameters that define authentication features:
Parameter Specifies
RunOSPF Enable/disable OSPF on the interface. When OSPF is active, the MAX
unit sends update packets out on the interface. These packets set the
correct link state for the interface and make sure that the local
link-state database is an exact copy of the database maintained by
other OSPF routers.
Area OSPF area to which this interface belongs.
AreaType Type of OSPF area to which this interface belongs. If a network is
large, the size of the database, time required for route computation,
and related network traffic become excessive. An administrator can
partition an Autonomous System (AS) into areas to provide
hierarchical routing connected by a backbone.
HelloInterval Number of seconds between sending OSPF Hello packets on the
interface. OSPF routers use Hello packets to recognize when a router
is down.
DeadInterval Number of seconds the unit waits before declaring its neighboring
routers down after it stops receiving Hello packets.
Priority Priority of this router with respect to the designated router and backup
designated router elections. When two routers attached to a network
attempt to become the designated router, the one with the highest
Priority value takes precedence. A router whose Priority is set to 0
(zero) is ineligible to become the designated router on the attached
network.
AuthType Type of authentication in use for validating OSPF packet exchanges:
Simple (the default) or None. Simple authentication is designed to
prevent configuration errors from affecting the OSPF routing database.
It is not designed for firewall protection.
Parameter Specifies
AuthKey An authentication key (a password), typically a shared secret with the
authentication server.
KeyID An authentication key (a password) used to allow OSPF routing.
KeyID is a number from 0 to 255 inserted into the OSPF packet
header. OSPF routers use KeyId to allow or exclude packets from an
area. The default value is 0.