Lucent Technologies 6000 - Manual (Page 179)

Configuring Individual WAN Connections
Configuring MP, MP+ and BACP connections
MAX 6000/3000 Network Configuration Guide 4-47
Encaps Options
Base Ch Count=1
(The settings shown for MP and PPP are required. The others are examples.)
If BACP is enabled, MP connections use BACP to manage dynamic bandwidth on demand.
Both sides of the connection must support BACP. In addition to the PPP parameters, MP
connections with BACP use the following parameters:
Ethernet
Answer
Encaps
MP=Yes
PPP=Yes
PPP Options
BACP=Yes
Dyn Alg=Quadratic
Sec History=15
Add Pers=5
Sub Pers=10
Target Util
Min Ch Count=1
Max Ch Count=1
Target Util=70
Ethernet
Connections
Connection profile
Encaps=MP
Encaps Options
BACP=Yes
Base Ch Count=1
Min Ch Count=1
Max Ch Count=2
Inc Ch Count=1
Dec Ch Count=1
Dyn Alg=Quadratic
Sec History=15
Add Pers=5
Sub Pers=10
Target Util=70
(The settings shown for MP and PPP are required. The others are examples.)
The MP and BACP parameters
This section provides some background information about MP and BACP configuration. For
detailed information about each parameter, see the MAX Reference.
MP without BACP
For MP connections without BACP, you can specify the base channel count, which must be
greater than or equal to the minimum count and less than or equal to the maximum count