Lucent Technologies 6000 - Manual (Page 184)

4-52 MAX 6000/3000 Network Configuration Guide
Configuring Individual WAN Connections
Configuring MP, MP+ and BACP connections
Dec Ch Count=1
Dyn Alg=Quadratic
Sec History=15
Add Pers=5
Sub Pers=10
Target Util=70
Note: For optimum performance, both sides of a connection must set the channel count
parameters to the same values.
8 Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring Lucent MP+ connections
Multilink PPP Plus (MP+) uses PPP encapsulation with Lucent extensions. MP+ enables the
MAX unit to use multiple channels for connecting to another MAX unit. BACP is not required,
because the Lucent criteria for adding or dropping a link are part of the MP+ extensions. In
addition to the PPP and MP parameters described earlier, use the following parameters for
MP+ connections (shown with sample settings):
Ethernet
Answer
Encaps
PPP=Yes
MP=Yes
MPP=Yes
PPP Options
Dyn Alg=Quadratic
Sec History=15
Add Pers=5
Sub Pers=10
Target Util
Min Ch Count=1
Max Ch Count=1
Target Util=70
Idle Pct=0
Ethernet
Connections
Connection profile
Encaps=MPP
Encaps Options
Aux Send PW=aux-passwd
DBA Monitor=Transmit
Base Ch Count=1
Min Ch Count=1
Max Ch Count=2
Inc Ch Count=1
Dec Ch Count=1
Dyn Alg=Quadratic
Sec History=15
Add Pers=5
Sub Pers=10