Lucent Technologies 6000 - Manual (Page 233)

Configuring Individual WAN Connections
Configuring POTS capability on the MAX 6000 and MAX 3000
MAX 6000/3000 Network Configuration Guide 4-101
FXS line profiles
There are five possible slot profiles for each MAXPOTS slot card. The first profile (default) is
always the active profile. You can save alternative configurations in the other four profiles.
Configuring an FXS line profile
To configure a slot (or line) profile in Main > Analog FXS > FXS Config > FXS Configuration
profile > Line profile, use the following parameters:
Saving alternative configurations
To copy the active profile to one of the alternate live profiles, proceed as follows:
1 From Analog FXS > FXS Config, select the active profile.
The active profile appears.
2 Press Ctrl-D to access the DO menu.
The DO menu appears.
3 Select S (Save).
4 Select the alternate live profile by using the Up Arrow and, Down Arrow keys, and press
Enter.
The active profile is saved to the specified alternative profile.
Activating an alternative profile
To activate one of the alternative profiles, copy any alternative profile to the active profile,
proceed as follows:
1 From Analog FXS > FXS Config, select the alternative (101, 102, 103, or 104) profile you
want to activate.
Parameter Specifies
Name Name of the profile.
Dial-Enabled Enable/disable outbound dialing through this profile’s POTS port.
Inc CallerID Info Include/do not include CallerID information for calls from this port.
Clid Number Telephone number of the caller.
Answer-Enabled Enable/disable answering of calls on this profile’s POTS port.
CallerID Do/do not forward caller-ID information to the POTS port. MAXPOTS
only supports the Bellcore Type I callerID format which might not be
supported in all countries.
Forward Disc Far-end disconnect indication is/is not forwarded to the POTS port.
Rx Gain Gain applied to the signal received from the connected equipment.
Tx Gain Gain of the signal transmitted to the equipment.
Signalling The signaling used on an analog loop. Regular telephones use Loopstart.
GndStart Ring Apply/do not apply ringing voltage to the ground start line.