Lucent Technologies 6000 - Manual (Page 247)

Configuring Individual WAN Connections
Configuring POTS capability on the MAX 6000 and MAX 3000
MAX 6000/3000 Network Configuration Guide 4-115
Active=Yes
Dst Chan Grp=4
For more information about MAXDAX functions, see the MAX Reference.
Routing inbound calls
When the MAX receives a call on a WAN line, it performs CLID or DNIS authentication (if
configured), answers the call, and routes the call to the MAXPOTS card. The following are
examples of incoming call routing.
Answer Number Routing
You can configure the MAX to route incoming MAXPOTS calls on the basis of dialed
telephone numbers. For example, consider a T1 line with DNIS numbers 555-6601 and
555-6602. The following configuration routes a call received at 555-6601 to Port 1 on the
MAXPOTS card (located on slot 3), and a call received at 555-6602 to Port 2 on the
MAXPOTS card (located on slot 3). (If the port is busy, the far-end will get a busy signal):
System
Sys Config
Net/T1
Line Config
Line Config profile
Line 1
Signalling=Inc-W-200 or Inc-W-400
Collect DNIS/ANI=Yes
Analog FXS
FXS Config
FXS Config profile 1
Line 1
Answer-Enabled=Yes
Analog FXS
FXS Config
FXS Config profile 2
Line 2
Answer-Enabled=Yes
Call Routes
Call Routes
Call Routes profile 1
Active=Yes
Phone Number=5556601
Dst Slot=3
Dst Port=1
Call Routes
Call Routes
Call Routes profile 2
Active=Yes