Lucent Technologies 6000 - Manual (Page 324)

6-38 MAX 6000/3000 Network Configuration Guide
Configuring X.25
Always On/Dynamic ISDN (AO/DI)
Configuring the Answer profile
To configure the Answer profile to allow support of AO/DI:
1 From the main Edit menu, select Ethernet > Answer profile.
2 Open the Encaps submenu.
3 Set MP to Yes.
4 Set PPP to Yes.
5 Close the Encaps submenu.
6 Open the PPP options submenu.
7 Set BACP=Yes.
8 Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring a Connection profile to support AO/DI
Before you configure a Connection profile to support AO/DI, you must understand each of the
X.25 parameters related to the Connection profile.
The following list displays the X.25 connection parameters whose descriptions appear
beginning on page 6-8.
Ethernet
Connections
Connection profile
Encaps=X.25/PAD
Encaps Options
X25 Prof
X25 Reverse Charge
RPOA
CUG Index
NUI
Call Mode
Answer X.121 Addr
Remote X.121 Addr
Configuring a Connection profile
To configure a Connection profile to support AO/DI:
1 From the main Edit menu select Ethernet > Connections > any Connection profile.
2 Set Active to Yes.
3 Set Encaps to MP.
4 Open the Telco options submenu
5 Set Call Type to AO/DI.
6 From the Connection profile menu, open the Encaps options submenu.
7 Set BACP to Yes.
8 Set both Base Ch Cnt and Max Ch Cnt parameters to the maximum number of channels
allowed for the connection.
9 Set InterfaceType to X.25.