Lucent Technologies 6000 - Manual (Page 346)

7-12 MAX 6000/3000 Network Configuration Guide
Configuring IP Fax
Atlas redialer and DID support on MAX 6000 units
Syslog support for IP fax operation
The following Syslog message reflects the time at which a modem was reserved:
LOG info, Shelf 1, Controller, Time: 15:36:40--
[1/1/13/0] [MBID 13] Assigned to Port
The following message displays the modem slot, modem number, dial-out number, and trunk
group when a call is placed:
LOG info, Shelf 1, Controller, Time: 15:37:07--
[1/1/13/0] [MBID 13; ->97476799] Outgoing Call, 97476799, Trunk 8
When the call is connected, its shelf, slot, line, and channel are displayed in a message similar
to the following:
LOG info, Shelf 1, Controller, Time: 15:37:13--
[1/14/2/5] [MBID 13; ->97476799] Call Connected
When the call is terminated, the time, modem slot, and modem number are displayed in the
following:.
LOG info, Shelf 1, Controller, Time: 15:38:00--
[1/1/13/0] [MBID 13; ->97476799] Call Terminated
Redialer support on MultiDSP card for store-and-forward fax
When a redialer device is attached to a fax machine, it waits for a 400 Hz tone. After receiving
the tone, the redialer transmits the destination fax number to the MAX as DTMF digits. With
the current software version, the MultiDSP card transmits the 400-Hz tone and detects
incoming DTMF digits.
Atlas redialer and DID support on MAX 6000 units
TAOS 9.0 enhances IP fax functionality by adding the Dialer Type parameter to the Atlas
redialer. This release also introduces the DID #N and InCall Type parameters, which
provide support for Direct Inward Dialing (DID) with inbound IP fax calls.
Ascend-CBCP-Trunk-Group applies only if one or both of the
following conditions are true:
• Calback Control Protocol (CBCP) is negotiated for a
connection.
• The call is an outgoing IP fax call and trunk groups are
enabled in the System profile.
Attribute Value