Lucent Technologies 6000 - Manual (Page 536)

14-16 MAX 6000/3000 Network Configuration Guide
Configuring Packet Bridging
Configuring bridged connections
Bridge=Yes
Recv Auth=Either
4 Open a Connection profile and set the following parameters:
Ethernet
Connections
Connection profile
Station=SITEBGW
Active=Yes
Encaps=PPP
Route IPX=No
Bridge=Yes
Dial Brdcast=Yes
5 Configure password authentication. For example:
Encaps options...
Send Auth=CHAP
Recv PW=localpw
Send PW=remotepw
6 Specify IPX server bridging and configure the timer for watchdog spoofing:
IPX options...
Handle IPX=Server
Netware t/o=30
7 Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring proxy mode on the MAX
If you are bridging between two segments of the same IP network, you can use the Net Adrs
parameter in a Bridge Adrs profile to enable the MAX unit to respond to ARP requests while
bringing up the bridged connection.
If an ARP packet contains an IP address that matches the Net Adrs setting in a Bridge Adrs
profile, the unit responds to the ARP request with the Ethernet (physical) address specified in
the Bridge Adrs profile, and brings up the specified connection. In effect, the unit acts as a
proxy for the node that actually has that address.