Tally Genicom T5023+ - Manual (Page 111)

Standard commands Print modes
T5023/5023+ - Programming Guide 101
Print modes
The use of different print modes (e. g., bold print, elongated print, underlining) ena-
bles a document to be structured for optical effect. This section describes the com-
mands for the selection of the print modes.
.
Command Function
SI Switch on condensed print
J
ESC SI Switch on condensed print
J
DC2 Switch off condensed print
J
SO Switch on elongated print for one line
ESC SO Switch on elongated print for one line
DC4 Switch off elongated print for one line
ESC W (n) Switch elongated print on/ off
J
ESC w (n) Activate / deactivate double character height
J
ESC E Switch on bold print
J
ESC F Switch off bold print
J
ESC G Switch on double impact print
J
ESC H Switch off double impact print
J
ESC - (n) Switch underlining on/off
J
ESC S (n) Switch on superscript/subscript
J
ESC T Switch off superscript/subscript
J
ESC ! (n) Select combined print mode
J
– By selecting condensed or elongated print the width of the charac-
ters is changed (condensed = 60% of the normal character width,
elongated = 200% of the normal character width).
– Not all print modes and character sizes can be combined. Invalid
combinations are pointed out in the description of the individual
commands.
– Using ESC ! (n) it is possible to switch on or off all print modes (with
the exception of superscript and subscript), the character sizes 10
cpi and 12 cpi, proportional spacing and italic print on or off with a
single command.
i