Tally Genicom T5023+ - Manual (Page 201)

Additional commands (Printer) Basic commands for document processing
T5023/5023+ - Programming Guide 191
Selection of type fonts/ character sets
Parameter:
n = type font or character set or font number (0 to 9999)
The font number is fixed when developing a specific character set.
Function:
Using this command by means of a type font or character set number n, special
character sets (fonts) can be selected which do not belong to the standard cha-
racter sets of the Epson protocol.
Extensions can thus be implemented without coming into conflict with the current
and future definitions of the standard Epson protocol.
CSI
ESC
27
1B
[
91
5B
n
n
n
n
#
#
35
23
q
q
113
71
Name
ASCII character
Decimal
Hexadecimal
– If a character set under the specified number is not a component of
the character sets range in the printing unit, the standard character
sets are switched over to automatically. This also applies if the cha-
racter set under the specified number does not contain the pre-
viously set character spacing.
– The character sets selected via CSI n # q do not offer the possibility
of producing characters defined by the user.
– After initializing the printer, there is also a switch-over to the stan-
dard Epson character sets.
i