Program steps (annotated) – Tally Genicom T5023+ User Manual
Page 253
Application examples
Processing of a blank form
T5023/5023+ - Programming Guide
243
Program steps (annotated)
1.
Switching on LQ mode
Command:
ESC x (n)
Parameter:
n = 1 (LQ mode)
2.
Switching on proportional spacing
Command:
ESC p (n)
Parameter:
n = 1 (proportional spacing on)
Remarks:
With proportional spacing setting the charac-
ter width is unnecessary.
3.
Setting line spacing
Command:
ESC 2 (1/6 inch)
Remarks:
This command is not actually necessary for
the example as 1/6 inch line spacing is the de-
fault value.
4.
Determining the document length
Command:
ESC C (n)
Parameter:
n = 72 (number of lines)
Remarks:
With line spacing of 1/6 inch and 72 lines, a
document length of 12 inches results. This
corresponds to the default value of the docu-
ment printer. Therefore
this program step could
also be omitted.
5.
Determining the left margin
Command:
ESC l (n)
Parameter:
n = 12 (position 12 with 10 cpi, default = 0)