Tally Genicom T5023+ - Manual (Page 200)

Basic commands for document processing Additional commands (Printer)
190 T5023/5023+ - Programming Guide
Paper feed of the document
Parameter:
Function:
This command initiates a mechanical action. The ejection procedure also refers
to documents which were only form fed and on which no insertion or print proce-
dure was carried out.
If this command is used to eject documents (n = 0), it must be considered that
after ejection the current logical position is outside the form. Therefore a new first
print position must be set here before transferring new print characters, for ex-
ample, using the command FF (form feed) or via paper feed of the document
(positioning on the base line of the logical first line, see definition of default po-
sitioning for
insertion) or using the command “Absolute vertical positioning”.
CSI
ESC
27
1B
[
91
5B
n
n
n
n
$
$
36
24
p
p
112
70
Name
ASCII character
Decimal
Hexadecimal
n = 0 : Ejection of a document
n = 1 : Insertion of a document to the base line of the logical first linewhich
can be set via the document printer menu (TOF- POS)
This control command triggers printing of characters still in the print buf-
fer. It immediately causes a mechanical vertical movement which can
be secured via a control cycle. Because a mechanical optimization of
movement is avoided by means of the insertion command, this control
command should only be used when the insertion procedure must be
secured separately via control cycles.
i