Tally Genicom T5023+ - Manual (Page 87)

Standard commands Horizontal print control
T5023/5023+ - Programming Guide 77
Setting the left margin
Function:
Using ESC l (n) the horizontal ’print position 0’ can be influenced, that is to say,
a left margin can be set. The left margin (absolute distance from the left edge of
the document) is determined by means of the value of n and the currently valid
character width. A value between 0 and 160 can be selected for n. The margin
resulting from this must not, however, be wider than 8 inches. If the left margin
width is defined as greater than 8 inches, the command is ignored.
n = 0: print position 0 = left edge of document
n > 0: print position 0 = left edge of document + n
ESC
27
1B
I
108
6C
(n)
n
n
ASCII character
Decimal
Hexadecimal