Tally Genicom T5023+ - Manual (Page 76)

Sheet ejection commands Standard commands
66 T5023/5023+ - Programming Guide
Determining the document length at n lines
Function:
ESC C (n) sets the document length at n lines in the selected line spacing. A va-
lue between 1 and 127 must be given for n. The actual physical document length
is then determined by the respective current line spacing.
It should be noted that the respective document length (n lines
∗
line spacing)
must not exceed the length of the document.
The current line, in which the print head is located on receipt of the command, is
fixed as the starting position of the document. A bottom margin set by means of
ESC N (n) is cancelled (see the corresponding command description in the “Ver-
tical print control” section).
ESC
27
1B
C
67
43
(n)
n
n
ASCII character
Decimal
Hexadecimal
If the print head is positioned beyond the edge of the paper (for examp-
le, for a document length of 12 inches), the printer issues an error mes-
sage (PAPER LENGTH). If a bottom margin is set logically on the paper
via ESC N (n) (for example, at 9 inches) and this margin is exceeded,
a form feed (FF) is executed.
i